Stephens Basic Humvee Build With Alittle Spice

Stephens Basic Build with a little spice!

 

This is a Bullet basic build with a few additional goodies. Stephen will be using this machine on his beach property! Hope he enjoys it as much as we enjoyed putting it together for him!

 

 

Below are the items we went over and replaced:

-Full Degrease and Pressure clean

-Remove all seats and hardware from the truck ( strip it )

-New 6.5L GEP motor

-New 60amp alternator

-New fluids and filters

-New smart box ECM

-New glow plug controller

-New glow plugs

-Kaskar grounding kit

-Fuel filter replacement

-Air filter replacement

-Diesel additive for injector pump seals

-Keyed ignition

-Check gauge pack for broken gauges and or sensors/ wires and replace

-Pressure test cooling system and reservoir tank

-Check all suspension and replace worn components

-new idler arm

-new pitman arm

-2 new tie rod ends

-2 lower ball joints

-check transfercase and seals

-drop trans pan and inspect and re seal and new filter

-New Top

-New Doors

-New Rear curtain

-New mirrors

-New hood bumps

-New hood latches

-2 front highback seat replacements with correct hardware

-New OE black seatbelts

-99% tread tires ( touched up in burnt black )

-Custom Bullet LED tag bracket

-New Trucklite headlights

-Custom Wiring

-Touchup of whole truck in Rapco Green

 

Additional Items

-Line X interior and dash

-24 volt tender

-24 to 12 volt converter

-fuseblock install

-USB charging port on passenger side

-Spare tire

-Jack

-New interior rear seat cushions and hardware

-OE brush guard painted in Rapco flat black

Leave a Reply